Jet boat turbine engine
This is the bowl we will use in Squirt 2. The intake screen turned out well. The square aluminum valve block on the port side in-front of the oil tank is the afterburner streak and main fuel control. Power turbine left and intake right. Squirt 2 Rocks! Here are some good shots of the engine mounted in Squirt 2 at the Toronto Boat Show. Squirt 2 on pad. Squirt 2 at the dock. This is the accessory drive shaft.
Surplus military turboshaft engines (helicopter engines) can easily be adapted to create turbine boats, jet cars, and many other turbine powered vehicles a few of. Installing jet engines in boats, Huey helo jet engines, make for the fastest These boats do become available for sale during and after the completion of the. SMOKE ON THE WATER. Real jet boats, which use turbine engines, can make you feel like you're flying across the water. BY MARSHALL BRODIE. There are.
All starting and accessory drive loads are transmitted by this little shaft.
The brake caliper will be mounted right on the back of the gearbox. Max input speed is 20, rpm. Here is me with my new toy. Needless to say proper stack up tolerances and assembly torque are critical here.
Speedorama Toronto. The press-fit is tricky considering the bearing must be heated and the alignment must be maintained for correct balance.
We are building all the. Take a lean aluminium jet-boat hull designed for racing; swap its heavyweight V8 engine for the gas turbine from a helicopter and you have. The Engine is the most unique item and the first to ever be installed into a river racing jetboat.
The Mercury Hp twin turbo racing engine is the most.
The SDG seals against the bearing housing with an "O"-ring, no gasket is used here. On the water.
Squirt 2 will be our second turbine jet boat. Our exhaust system is fabricated from a special alloy stainless material used in the military that is designed for this application.
Video: Jet boat turbine engine Ryan Rogers Turbine Jet Boat test run
Power turbine left and intake right.
The motor is environmentally sealed with a built-in internal fan for long life. This is my brother Steve Nye's slick idea for stacking the power turbine assembly.
Fitting Engine. It's hard to believe you can get 1,hp 20,rpm out of this little 14" wheel. Power turbine left and intake right.